how to install clopay garage door keyed lock set

Afterward, check the inside of the section to make sure the holes are evenly spaced. The drill bit must be perpendicular to the outside of the section.

Drill three 3/16″ holes from the outside and into the inside skin of the section.

The outside T-Handle installs vertically or horizontally, as shown below. On odd-size doors, it will be off centered. This would normally be in the center of the section. Locate the outside stile where you want to install the lock. Instructions for Installing Locks on Sandwich Doors

Install the two long screws that connect the inside and outside handles.

Then, install the inside release handle.

Faster speeds are better because slower speeds tend to rip the thin sheet metal.

Drill the three larger holes in the outside skin only of the door.

Also, check the outside of the section to make sure the holes are evenly spaced.

Then, center the drill bit in the holes and perpendicular to the section and stile. Drill three 3/16″ holes from the inside using the holes in the stiles as a guide.Notice how the lock lines with the holes. Or slightly below center, as you see in this hollow, or non-insulated door. These may be centered, as you see in this insulated pan door. If you have a pan door, locate the center stile, and the holes punched for the lock.Instructions for Installing Locks on Pan Doors Most steel doors are either pan doors with stiles joining the edges of the sections or sandwich doors with steel on both sides bonded to the insulation. Sometimes the 3/8″ hole needs to be enlarged slightly. This is key to a properly aligned and functioning lock.Īfter drilling these holes, larger 5/16″ holes and a 3/8″ hole will need to be drilled on the outside skin of the section only, but not on the inside. First, drill three holes with 3/16″ bits.

Install the outside keyed handle and the inside release handle.ĭrilling for the lock will be a two-step process. To prevent this from happening, you will use the two red spacers above.

If you have a foam-filled door with steel on both sides, the metal on each side will compress when you tighten the screws that secure the outside handle to the inside handle. Whereas, the other system uses two sash chains and small S-hooks to link the inside handles and spring latches. On single-car doors there is often only one latch. The cable runs from the spring latch on one side through the center inside the release handle and on the other side where a track bolt and nut secure the cable to the spring latch. The more common lock assembly uses a cable to connect the outside lock keyed T-handle to the spring latches. Here are instructions on how to install the two most common lock assemblies we sell. Garage door locks are normally installed in the center of the section just above the bottom section.

How to install clopay garage door keyed lock set